If you play a Brass Instrument Service, proper care and maintenance is essential to keep your instrument in good condition. Here are a few tips to help you get the most out of your instrument. First, it’s important to clean your instrument regularly. Use a soft cloth and warm water to remove any dirt orbuildup on the surface. Be sure to avoid using harsh chemicals or cleaners, as these can damage the finish of your instrument.
Next, it’s important to oil the moving parts of your instrument on a regular basis. This will help to keep them from drying out and becoming sticky. Finally, be sure to take your instrument to a professional for service on a regular basis. A professional can inspect your instrument for any potential problems and make any necessary repairs. By following these simple tips, you can keep your brass instrument in top condition for years to come.
Maintenance of brass instruments is very different from strings and woodwind. Described below are the 3 main things involved with their care.
Wash – it is recommended to clean your instruments internally regularly. Run a warm bath with a little washing liquid to soak the instrument (this does not include rotor instruments such as French horns, rotor tubes and rotor thrombon, because internal mechanisms require special attention that must be handled through quality instruments improvement.). Leave about 10 minutes in the water after removing the valve before soaking the main body. Then run the instrument with warm water to rinse the remaining soap.
Cleaning – Brush all tubes with “snakes” (long cable cleaning brush). There are also brushes used for valves and brushes for funnels (this must all be available from music stores). Nb. If you have given the bathtub instrument before cleaning the valve and tube, make sure the instrument has completely dried before re-assembling.
Lubrication – Trumpets: Open the valve and completely loose (if you take a shower first) or lift half the way. Apply the valve oil to the width of the valve and push the valve back to the position. All valves have a guide to hold it properly. If you are not sure if the valve is correct, turn the valve gently. CLICK Softly will be heard once in place and the valve no longer wants to move. Placing the finger at the top of each valve cap, push up and down until the action is smooth. A drop of valve oil is also needed to cover the bottom of the valve before replacing it. N.B All valves are numbered so they are installed to the correct location without error!
Thrombon: Apply a little sliding oil to the slide and assembled. For the main slide, use oil slide cream.
General accidents – carefully don’t overdo it when inserting funnels. This can be easily jammed, although most music companies have appropriate equipment to remove them and will not charge this service. Do not rely on the instrument bells when applying a funnel or just resting from playing. This is an expensive mistake and although it can be fixed, it should be avoided!
When cleaning, be careful when removing slides, valves, and lid under the valve. Every dented made on the instrument bell is much easier to return than if the slide itself becomes a dent. If doubt or if the slide and valve do not move with soft pressure, bring it to the instrument servants who meet the requirements rather than taking further risks to damage the instrument.
The safest place for instruments that are not played is in the case.
Conclusion
Thanks for reading our guide on brass instrument care and service. We hope that you found it informative and helpful. If you have any questions or need more information, be sure to visit St.John’s Music website or contact us directly. We’re always happy to help!
